Heating aluminum sheet for photovoltaic panels
(Item code FT1E-ALU)Easy-to-install snow melting solution for photovoltaic panels, which allows energy production even in the event of snowfall.
Application Area:
Thermal expansion absence is guaranteed by Thermal Technology with special carbon fiber resistors.
After snowfall, a layer of snow is deposited on photovoltaic panels, decreasing their performance until total shutdown. Once installed, heating sheet from Thermal Technology does not permit snow accumulations, preventing the obscuration of the panels.
Easy installation in 3 minutes
Without any type of specific tool, even the less experienced will be able to easily apply the exclusive Thermal Technology heating films to solar panels in just a few minutes.
Operational Features:
Heating sheets can be easily installed. They are composed of double layer of adhesive aluminum and are bonded on the panel’s rear side. May be connected to each other up to seven heating sheets, using bipolar connectors. During snowfalls the heating is turned on, in order to prevent snow accumulation, and it is turned off only after entire release of the panel’s surface from snow. If outside temperature is higher than 10°C the device should not be turned on..
Carbon fiber is flexible, does not oxidize, does not produce harmful electromagnetic fields during electricity flow, has no dimensional variations as the temperature changes nor deterioration of ohmic values. No wearing and no maintenance required. Its high resistivity permits significant energy savings.
Stratification:
From outside:
• External side is made of adhesive aluminum of 0,5 mm
• Carbon fiber resistors
• Inner side made of adhesive aluminum of 0,5 mm
You have a project in mind and want
a proposal without obligation?
Contact us now and you will soon receive an answer.
Contact us