Radiant panels, obtained by inserting of carbon fiber resistors inside of gypsum board, are perfectly adaptable to any type of indoor coating, both wall and ceiling. Radiant heating principle of the system does not cause air movement, avoiding dust and acrid circulation.
NO HARMFUL ELECTROMAGNETIC EMISSIONS
The installation can be done on walls, fake walls or fake ceilings, using the special metallic profiles, which can be easily purchased in appropriate stores. The panel is mounted on the wall in the same way as a common plasterboard. The panels are connected using IP67 connectors, placed on board’s edges, or using appropriate extension cords (see the table), if necessary.
Stratification starting with outside layer:
Gypsum fiber plate, thickness 12,5 mm (0.49 in), with groove on the back side for carbon fiber resistor housing.
Carbon fiber resistors insulated with special polyolefin coating.
Reflecting aluminium sheet.
Activation and deactivation of the heating system can be automatized by aim of an electronic controller (T705) operating with temperature probes, which must be installed in the heated area. Furthermore, the installation of a thermostat or chrono-thermostat is enough to control efficiently the temperature in the room.